Fully insured · Free estimates · Panel upgrade specialists Mon–Sat · 8:00am–6:00pm

Our specialty · 100A · 150A · 200A · 400A

Panel & Service Upgrades

This is the work we do most and the work we do best. If your panel is full, hot to the touch, or still the original from when the house was built, it is not keeping up with a modern house. We size the new service properly, pull the permit, coordinate the utility disconnect and reconnect, label every circuit, and leave you with capacity you can actually build on.

Electric Power Pro Solutions · McKeesport, PA 15132 · (412) 899-2364

A newly installed 200-amp residential load center with conductors dressed and every circuit labeled

What’s included

  • Full service upgrades — 100A, 150A, 200A and 400A
  • Load calculations done before we quote, not after
  • Main breaker panel and load center replacement
  • Meter socket, mast and service entrance cable replacement
  • Sub-panels for additions, garages and finished basements
  • Whole-home surge protection at the panel
  • Permit pulled and inspection scheduled — we handle it
  • Utility coordination for the disconnect and reconnect
  • Every circuit traced and labeled before we leave

Why it matters

Electrical work is one of the few trades where the difference between good and bad is invisible until it isn’t. A job done properly is permitted, inspected, correctly grounded and bonded, sized for what you actually run, and labeled so the next person — another electrician, a home inspector, the next owner — can read it without guessing.

That is the standard on every job we take, whether it is a single circuit or a full service replacement. We would rather do fewer jobs properly than more jobs quickly.

Where we do this work

Greater Pittsburgh and the whole Mon Valley out of our base in McKeesport, reaching ten counties in all — Allegheny, Westmoreland, Washington, Fayette, Armstrong, Indiana, Butler, Beaver, Greene and the corner of Somerset. See the full service area map.

Straight answers

Common questions

How much does an electrical panel upgrade cost in the Pittsburgh area?

It depends on the service size, the condition of the existing service entrance and what your municipality charges for the permit. That is why we look at it in person and give you one written number covering labour, materials, permit and inspection before any work starts. The estimate is free.

How long does a panel upgrade take?

Most residential service upgrades are a single day. The power is off for part of that day while the utility disconnects and reconnects, and we schedule that window in advance so you can plan around it.

Do I need a permit to replace my electrical panel?

Yes. A service or panel replacement is permitted and inspected work everywhere in our service area. We pull the permit, meet the inspector and hand you the paperwork, which matters the day you sell the house or renew your insurance.

My house still has a fuse box. Is that actually a problem?

It can be two problems. Insurers increasingly refuse to write or renew policies on fuse boxes, and buyers routinely walk at inspection. Beyond that, a 60-amp fuse service simply cannot carry a modern house. Converting to a breaker panel resolves all of it.

Free written estimates

Panel maxed out? Breakers tripping? Let’s take a look.

Tell us what the house is doing and we’ll tell you straight whether it needs an upgrade or a repair.

Electrical Panel Upgrades for Pittsburgh, PA Homeowners

Electric Power Pro Solutions handles the full scope — load calculations, permits, utility coordination, and final labeling — so your new panel is ready to carry a modern household from day one.

Why Pittsburgh-Area Homes Need Panel Upgrades More Than Most

The housing stock across McKeesport and the broader Greater Pittsburgh region skews old. Most river-valley boroughs — Duquesne, Clairton, Braddock, Homestead — were built out during the mid-century steel era, when a 60-amp or 100-amp service was considered more than enough. Those same homes are now running central air, electric dryers, chest freezers, and multiple device charging stations at the same time. The original service was never sized for any of that.

Allegheny County and the municipalities throughout our service area require a permit and third-party inspection for any service or panel replacement. That inspection record becomes part of the home's permanent file and matters directly when you sell, refinance, or renew your homeowner's policy. Insurers writing policies in this market increasingly flag unpermitted panel work or older fuse-based services as grounds for denial or non-renewal — which means the paperwork we hand you at the end of the job has real dollar value.

Older housing stock in Mon Valley communities also tends to carry knob-and-tube or early aluminum branch wiring in parts of the house, which affects how a panel upgrade is scoped. We note what we find during the estimate walk-through so nothing surfaces as a surprise once work starts.

What a Complete Panel Upgrade Actually Involves

A panel upgrade is not just swapping one box for another. Before we quote, we run a load calculation — tallying what the house actually runs so the new service is sized for your real demand, not a rough guess. That number drives everything: the service amperage, the breaker slots you'll have room to grow into, and whether a sub-panel makes sense for a detached garage or finished basement.

From there we pull the permit, schedule the utility disconnect window, and coordinate the reconnect so the power outage is planned and brief. We replace the main breaker panel and load center, the meter socket, the mast, and the service entrance cable as the job requires. Before we leave, every circuit is traced and labeled. The permit paperwork and inspection sign-off go to you.

The result is a panel another electrician, a home inspector, or a future buyer can read without guessing — and one that's ready to carry whatever you add next.

Common questions

How much does an electrical panel upgrade cost in the Pittsburgh area?
Cost depends on the service size you need, the condition of your existing service entrance, and what your municipality charges for the permit. In this market, full residential service replacements commonly land in the low four figures, but the spread is wide enough that an in-person look is the only honest way to quote it. We give you one written number covering labor, materials, permit, and inspection before any work starts — and the estimate is free.
Do I need a permit to replace my electrical panel in Allegheny County?
Yes, everywhere in our service area. A service or panel replacement is permitted and inspected work by code in Allegheny County and the surrounding municipalities. We pull the permit, meet the inspector, and hand you the signed paperwork — which matters directly when you sell the house, renew your insurance, or refinance.
My Pittsburgh home still has a fuse box. Is upgrading urgent?
It depends on your situation, but two issues come up consistently: insurers in this market increasingly refuse to write or renew policies on fuse-box services, and buyers routinely flag them at inspection. A 60-amp fuse service also simply cannot carry a modern household's load. Converting to a breaker panel resolves all three problems — coverage, resale, and capacity — in one job.

Get a Free Written Estimate

Tell us what the house is doing — tripping breakers, a panel that's full, or a fuse box you've been meaning to replace — and we'll tell you straight whether it needs an upgrade or something simpler.